Hot Water List

Lochinvar ATHR-160M 1**

Lochinvar ATHR-160M 1** is in the DOE listing as of Oct 19, 2026. Lochinvar ATHR-160M 1** is in the ENERGY STAR list as of Oct 19, 2026.

  • Gas tankless water heater
  • 2 listed models

Its figures are also listed under A. O. Smith ATHR-160M 1**.

Certified and advertised figures

Flow at a 67°F rise
4.8gallons per minuteCertified
Advertised flow
4.8gallons per minuteLochinvar, at a 67°F rise
UEF
0.95Uniform energy factor

Flow where you live

A bigger rise from colder incoming water leaves the heater with less flow.

Cold water
Cold water must be at least 10°F colder than the hot water setting.
Flow estimate
The estimate uses the lowest certified flow among the listed models. It is about 4.6 gal/min at a 70°F rise.

Flow limits

  • The estimate excludes the flow needed to turn the heater on, heat lost in pipes, and installation.
  • Cold water from a well or long pipe run can differ from the temperature you enter.
  • Without a stated flow limit, estimates for warmer water may exceed the heater’s actual flow.

Advertised and certified figures

Lochinvar ATHR-160M 1**: advertised and certified
Lochinvar ATHR-160M 1**: advertised and certified UEF: advertised 0.95, certified 0.95. Flow: advertised 4.8 gal/min, certified 4.8 gal/min (advertised at a 67°F rise, certified at a 67°F rise). UEF Advertised 0.95 Certified 0.95 Flow · advertised at a 67°F rise, certified at a 67°F rise Advertised 4.8 gal/min Certified 4.8 gal/min
Lochinvar ATHR-160M 1**: advertised figures, where and when read
FigureAdvertisedCertifiedAdvertiserRead
UEF 0.95 0.95 Lochinvar Read Oct 4, 2026
Flow 4.8 gal/min at a 67°F rise 4.8 gal/min at a 67°F rise Lochinvar Read Oct 4, 2026

See how advertised flow compares across tankless models

Certified figures by listed model

Lochinvar ATHR-160M 1**: certified figures by listed model
Model numberUEFFlow at a 67°F rise (gal/min)Recovery efficiencyDraw pattern
LTHR-160M 1**0.954.898%High
LTHR-160X3 1**0.954.898%High

UEF is the uniform energy factor. A dash means the model has no such figure.

ENERGY STAR certified models

Lochinvar ATHR-160M 1**: ENERGY STAR certified models
Model numberUEFFlow at a 67°F rise (gal/min)Recovery efficiency
LTHR-160M 1**0.954.898%
LTHR-160X3 1**0.954.898%

At a 67°F rise, its flow in the test is 4.8 gallons per minute. The gas tankless type has a median flow of 4.8 gallons per minute. Among 487 gas tankless models, 221 give more flow at a 67°F rise.

Under this basic model, 2 model numbers are ENERGY STAR certified. In tests, 95% of the energy went to hot water, so its UEF is 0.95. In the test, daily hot water use was set to high (its draw pattern). Of 399 gas tankless models with the same draw pattern, 49 have a higher UEF. For its type and draw pattern, the UEF runs from 0.81 to 0.98. While it heats water, 98% of the energy used goes into the water (its recovery efficiency).

It is the basic model for LTHR-160M 1** and LTHR-160X3 1**. There are 6 more basic models with the same test figures. They are listed under 6 other brands, one each. For the full group, see the A. O. Smith ATHR-160M 1** page.

It may qualify for 6 rebate programs. Another 2 programs may accept it if it meets their other terms.

Also listed as

They carry every figure in the table above.

Rebates

Programs change their terms. Check the program's own page before you buy.

Updated Oct 19, 2026 · Methodology

Not covered

  • Changes to an advertised figure after the date beside it.